Suggestive Way to Solder a Bronze Water Valve

Suggestive Way to Solder a Bronze Water Valve

Bronze water valve refers to the valve used in mostly water systems. Such valves are mainly manufactured in bronze. Generally speaking, bronze is widely applied because of the excellent anti-corrosive performance. As a result, various bronze water valves have been widely applied into plenty of industrial fields. In most cases, they are soldered into the pipes to take effects. To be frank, the soldering process would be smooth with the help of a proper torch. Even though this task would be moderately challenging, we can try to do it in case of emergency situations. Patience and carefulness are quite significant during the whole process.

In order to complete this challenging work, there are some tools available to make the process smooth and effective. The common tools can be the wood cloth or sandpaper, metal brush, flux, lead-free solder, plumbing torch and rag and other necessary ones.

At first, it is wise to have a clean pipe. The wool cloth or sandpaper can be used to take apart of the dirt, grease or grime. If necessary, the metal bush can be applied to clean off any narrow spaces. And flux can be used to help clean and facilitate the soldering process.

Then, it is wise to choose a proper solder for the specific bronze water valve. Generally speaking, it is appreciated to choose a lead-free solder or solder with less than 5 percent lead. Such mechanisms are suitable for water systems.

Afterwards, it is the core step. Use the solder to connect the valve to the required pipe. Before its very beginning, it is necessary to heat the required water valves and pipes. The plumbing torch can do help. The heating time had better last 10 to 20 seconds. But it should be cautious enough to ensure the plumbing torch is not near some combustible chemicals or materials.. Once heated, the flux we have rubbed on the surface would turn to crackle and evaporate. At this moment, wrap the chosen solder around the heated joints. The solder melt onto the pipes until it cools down. It is necessary to clean off any residual flux with a rag. At this moment, all work has been successfully done. Congratulations!

SeekPart.com is the global B2B platform in the industry of mechanical parts. SeekPart aggregates the trade leads in this area, and our ultimate target is to benefit the buyers and sellers of mechanical parts by utilizing these leads through our online tools.

Click for more information about the seekpart

Article from articlesbase.com

Consumer Notice: This web page may contain affiliate links which means if you purchase something through them I may get paid an affiliate commission. However, you could find exactly what your searching for!

Be Sociable, Share!
This entry was posted in Weller Soldering Info and tagged , , , , , , , , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

*